Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I want to deploy a kind of high availability with two 6509-E switches, running IOS, and configuring HSRP in order to have one virtual IP address as the gateway; In this moment I only have one switch (a 6513 with double sup2), so, I have the inter...
I have 6 catalyst 6500 switches, all of them with Cat0S cat6000-sup2k8.8-3-7.bin and I recently configured port security feature in order to limit the number of MAC addresses that are permited in each port at a time; I configured this on each port:se...
I want to know how much delay I would get if I configure md5 authentication in my eigrp neighbors; I guess it is not much, but I 'd like to have the info, if somebody knows I'll apreciate itthanks
Thanks Roberto; I read it, and I understood that I have to run hsrp on each vlan, but, what do I have to do with the connection, in order to connect the two switches I need to connect them with one cable, a trunk? if not, do I have to configure ip ad...
thank you for answer me, I read the documentation you sent to me, but, the problem is that I have the next configuration in switch 1, and with the new topologie composed by two switches in HSRP one of them, the second one doing the job of uplink back...
hi!I have been reading the messages, because I have the same problem, with my almost 10 AP's in my local network, I have this ios version 12.3-7JA1. But also another 20 AP in other cities with the same ios version but without the problem, only my AP'...