Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there everyone! Can someone tell me the latest version of IOS that will run on a Cisco 2621 router? I am running 12.3(24) currently, but i'd like to run SSH version 2. Apparently the version I am currently running only supports version 1.5.Thanks...
Hello again, I am running a Cisco 2621 router with iOS version 12.3(24) and I would like to set up SSH version 2, however, I see only version 1.5 is installed. Is SSH version 2, or 1.99 available on this version of iOS? I have googled and have not c...
Hi there, I am setting a small Cisco lab on my home LAN, and am looking to configure a 2621 router to connect to my ISP. I would like to have this router on the same subnet as the existing router from the ISP, if that is possible. Am I missing anyt...
gateway1(config)#ip ssh ver^% Invalid input detected at '^' marker.gateway1(config)#ip ssh ?authentication-retries Specify number of authentication retriesbreak-string break-stringlogging Configure logging for SSHport Starting (or only) Port number t...
Tried that, this is what I am seeing:gateway1#enablegateway1#conf tEnter configuration commands, one per line. End with CNTL/Z.gateway1(config)#ip ssh version 2^% Invalid input detected at '^' marker.
I have followed the setup procedure as described in the link, and have set up SSH 1.5 successfully, but it is only version 1.5. If I type:#ip ssh version 2, i get an error as follows:router#enablerouter#ip ssh version 2^% Invalid input detected at '...
