Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our study group are stuyding about routing and switching these days.I will place UTM firewall instead of ISP router(will remove nat on router), and use bfd with mhsrp.Thanks for any tips for improvement those network without removing any devices.
https://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-software-releases-120-mainline/47205-cef-whichpath.htmlI found how to set Switching Method for CEF, Fast only on above doc.For configure process Switching, should I set process switchi...
I've started network one and half month ago, so I don't have much knowledge.After I failed to figure out process switching, and then I saw that table you left on cisco doc.But you know, that made me confused. Because Ingress Interface's switching typ...
For configure process Switching, should I set process switching for both inbound and outbound?Above is my original question.I knew how to make process switching with 'no ip cef' , 'no ip route-cache'So I did it on my router's output interface and it ...
That's really valuable information Actually I've been taking a kind of networking class, and I learned 3 kinds of switching types.We tried to figure out how all kinds of switching works by debugging ip packets, but 'process switching' was not workin...
