Dears, OSPF diagram show as belowR1 (Area 12 ) ---- R2( Area 0) ---- R3 (Area 0)---- R4(Area 10)if only R1 loopback 0 interface advertised to R3 and only ABR router summurize to Area 10 , how to configure Best Regards,
The solution of this eBGP LAB configure show as below. Please verify if the configuration is any missing or suggestion. Thanks!
R1>enableR1(config)#R1(config)#router bgp 10R1(config-router)#bgp router-id x.x.x.x // x.x.x.x is R1 Loopback0 ip ...
Thanks all for discussion , I understand OSPF summarization , the prefix list and the fliter list and one more thing I want to know is how to calculate the link cost (bandwidth and cost measure) of Router between OSPF Router
Dear HHM ,Task 2 Advertise R2 Loopback 100 and 200 interface to AS400 and AS 500 , why your configure only Router bgp 500 , is need to add Router bgp 400 in the configure ?
Thanks for your help ! I want to question before I configure R1 router ,I need to check R1 router Loopback 0, 100 and 200 ip address first . Is that use
show ip interface brief
command to perform ?
Another question is how to configure Loopback addr...
