Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hoing someone can see what is going on here..
I have a clients site that io have configured a layer 3 FTTP NBN connection, the ISP only support PPOE and no EoIP, I have set the virtual interface Dialer1 and configured everything as far as i'm aware...
Hi,
I have a HWIC-3G-HSPA setup as a SLA failover link in my 1941. All works fine and if the primary WAN interface goes down the 3G link comes up and all is good. But the cellular link times out and shuts down after about two days. I've set the dial...
Hi,
Ive finished configuring our new 1941 and its running smoothly so far, this is a production router and i want to ensure the configuration is as complete and secure as possible.
I am planning to block ICMP on the WAN interface and require a few ...
Thank you for sharing this! I was stuck trying to figure out why the helper wasn't passing on IPs and i had SVI with helper and VLAN configured. As soon as remove the SVI the issue resolved.
This works, thanks for posting..This solution saved me time trying to work out what the error referred to.Version file names from Cisco are:sx200_fw_1.3.7.18.ros - Firmwaresx200_boot-13506.rfb - BootAll good now
@Georg Pauwen Thanks for confirming the correct config based on ICMP results. I worked the same answer out through calculation, in the end left my configuration in place and raised a ticket with the ISP to check their configuration. They never told ...
Hi George,
Thanks for your reply, I tried this and still getting fragmentation.
I have my dialer interface set to:
interface Dialer1 description Primary Virtual WAN Interface mtu 1460 ip address negotiated ip access-group 100 in no ip redirects n...
