Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone talk to the technical differences between AVS and VDS? Looking for some specifics as to why a customer should choose one over another.
Thanks!!
Hello - Looking to buy a couple of C220 servers with Cisco VIC 1225. The plan is to connect this CNA adapter to a 10GBaseT module on a 3750-X. Want to make sure this will work. Can someone confirm? Also, will I able to carve out some virtual NICs on ...
Folks - I am running UCS 2.0(1w) and have a total of 4 chassis, with 2 of the chassis not showing up in UCS Mgr. The 2 chassis that are not showing up have a single full width blade (which does not have any template assigned yet). All the server port...
Hello folks -As depicted in the picture, I have a Cisco ASA firewall with one interface connected to one ISP router (R1) and another interface connected to another ISP Router (R2). R1 is used for all incoming FTP traffic and R2 is used for all incomi...
Hello all -I have a Cisco layer 2 switch with multiple VLANs on it. One of the VLANs is a user VLAN. The switch has a trunk port to a Cisco router, and all VLANs are being trunked to the router. Router is conifgured as router-on-a-stick.I have config...
I did some more reading on CBAC's. Contrary to what I mentioned in my original post, there is no need for an ACL on the inside interface if all the traffic is being permitted. However, we still DO NEED inspect command either on the inside interface o...
Jennifer -Since the self zone is automatically created for all IP's on the router, both the MPPP and the Tunnel interface on the router will reside in the self zone. That being said, I am not using the self zone in any zone pairs. Therefore shouldn't...
So in this case, what benefit do I get from using enhanced service objects? Since I am only using port 80, 443 I could have used a protocol specific service object as indicated below, correct?object-group service test tcpport-object eq 80port-object ...
None of the addresses referenced in the error message appear in the xlate table. This is the expected behavior since the error message states that it is unable to create a NAT translation for the host in question.Still scratching my head on this one....
