Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a our users on a 40mb X 5mb connection. I noticed when installing an application from the internet this router installs at like 650kb our old router would install the same application at aroun 1.2mb I did some tests switching them out on the ...
I have a 1921 k9 router that has several DHCP pools configured. Before implementing the firewall they were all working. After implementing it they stopped working. I messed around and got the routed port GE0/1 handing out IP addresses and left it alo...
I have a 1921 K9 with a 4 port 10/100/1000 EHWIC switch. Interface 0/1 = 192.168.1.0EHWIC = 192.168.5.0 I have Active Directory setup on the 192.168.1.0 network. When I attempt to join the domain from 192.168.5.0 it joins but I get errors. After some...
The Cisco 1921 router has two routed adapters. One is GE0/0 which I am using for my WAN interface. It is working properly. The 2nd interface is GE0/1 which is being used as my internal adapter. It is running NAT. When I attempt to reach the internet ...
Alright I have a cross over cable I will use it next time. What exactly do you mean your second post? Are you talking about this lineno ip dhcp excluded-address 192.168.1.10 192.168.1.254I went ahead and restored to an earlier version of the config. ...
I sent you a PM. I loaded the config but it has made the router unuseable. None of the interfaces work either via DHCP or static IP address and I am unable to connect to the router via SSH from 192.168.1.0 (GE0/1) I am in the process of reloading the...
I dont mind changing the config. This is my 1st time setting up a cisco router. The reason I used the vlan-interfaces is because that was the first way I figured out how to get VLANs running on the router.
Will this allow all UDP communication or only communication on the UDP ports defined in the policy map?I added this to the running config and tested the ports still return the filtered value. I already opened the ports in the windows firewall so I do...
