Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have 4 WAP551s at one of our sites, and I have discovered a problem whereby they stop distributing/passing through DHCP addresses to clients. This happens roughly every 2 days, at which point I simply reboot them all and magically the clients ...
Hi everyone,I'm still quite early in my network learning path so be nice If I say anythign stupid forgive me!I plan to build improved redundancy in to my LAN by stacking two 3750s and teaming pairs of NICs on my Dell PowerEdge servers, with each cab...
HiI need to know the maximum number of MAC addresses that can be entered in to the MAC security filter list on the AP541N.I know it has a maximum number of 200 concurrent users, however the documentation does not specifiy whether this also applies to...
Hi Eric,I have a new case open now - 634062045. I've provided the technician with the packet captures and topology details of the network. Fingers crossed for a resolution as this has been driving me mad! Cheers
I thought this issue was resolved but sadly it is still occurring.I have tested with 3 different laptops; one gets an IP address from the DHCP server - the other two don't. These tests were performed within minutes of each other.I set up wireshark on...
Sadly this issue is not resolved. I am on site today and could not get an IP address when trying to connect to the wireless network. This was affecting 2 of the 4 WAPs on the site. The one I normally have the issue with is working OK.I then plugged d...
I've moved the WAP to a different switch port and factory reset it, then joined it back to the cluster. No problems in last 24 hours since doing this. If problems occur again I will post the switch configs.
