Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a small network which consist of a pfSense firewall, Cisco SG300 28-port Switch (L3 configured) and Cisco WLC2504 controller.The pfSense firewall acts as the DHCP Server and I have configured a couple of VLANs. Everything seems to work OK exce...
Hi all,I have some problems setting up my WLC2504 with a SG300 Switch configured as a Layer3 Router.Basically, I have followed the tutorial I found on this site.What I have done to both devices, is listed in the step-by-step documents that are attach...
Hi All,I'm fairly new to Cisco Wireless LAN but have 5 AIR-CAP1702 access points connected to a 2504 WLAN controller.The set-up is used in a small (home) office environment so it's not used in a big company or office.Nevertheless, since the support o...
I've red the deployment guide and I will try the LAG feature of the WLC to connect to my SG300 switch.However, almost every example I see is either with a Catalyst switch (with a different IOS software and configuration steps) or with a switch where ...
Hi @Flavio Miranda ,Thanks for all the help but I have found the issue once connected to the Console port of the Access Point.I have seen this setup working before on another location, so I knew it wasn't a compatibility issue and I also knew they we...
Hi @Flavio Miranda ,Thanks for the info and indeed that was my fault indeed!When I change this as you suggestion, I can reach all devices on the Management VLAN.Also I'm able to connect to the Management GUI's of both the WLC and the SG300 switch.How...