Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an odd one:I'm setting up my CCIE lab, I get my CUCM and CME working no issues with IPC.Then I get to the second portion, add a CME with a couple of 7940's, they won't get DHCP? So I try everything and finally remove the switchport voice Vlan ...
Hi Everyone,This may / may not be a simple question.In an MPLS enviroment we use shaping on a part bearer to throttle bandwidth to the ISP specified amount, but we still are having issues.So what we did as a secondary method was to wrap a policer aro...
Hey Tim,It was kind of obvious I wouldn't need voice vlan once I flattend it, I did try a trunk,Config was just standard stuff I've done hundered's of times, just got the 3524XL today. I suppose I've been pampered in the work place with 3750's and Ca...
What's with the Disclaimer ? LOLSorry, moving on. The issue is dropped packets, the wan is being saturated.. This being a part bearer a shaper is needed, the ISP runs over Sonnet so we have already accounted for this by setting the CIR of the shaper ...
Hi Raph,There are a few ways you can approach this, Get a router than can hande more PPS (Like Rick suggested). Or get another router and use a per flow load balancing selection, this is dependant on your setup of course. So you may have to think abo...
