Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am designing a data centre with VSS, FWSM & ACE. I am using the design guide below as a start point, using the red service chain.http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/ACE_FWSM.htmlmy topology will be routed access with...
Hi,I have an issue deploying a policy with QPM; The policy I am deploying gets stuck on the "in progress" state and never deploys properly. Looking at the CLI of the router I can see some of the policy commands have been entered from QPM, but the job...
Hi,I am about to deploy QPM 4.1 for a customer in a Windows environment where all the various NMS usually have two network cards in two different networks - one NIC to manage the server application with, and one NIC in the network device loopback man...
Hi,I am trying to confirm CUOM monitoring support for the 4500-Sup6 engine. The supported devices matrix for CUOM v2.1 only shows support for the WS-X4515 and below (Sup4, 3, & 2)I wondered what level of monitoring CUOM can provide for the Sup6 engin...
Hi,I am trying to find a MIB for the ISR routers (2801, 2811, 2821, 3825 and 3845) which will allow me to query the equivalent value as: show policy-map interface or somnething along these lines.I believe I may need either/or;CISCO-QOS-PIB-MIBCISCO-C...
Hi Dom,Thanks for the response. All good answers, which help this design! I will clarify question 4 a little for you - I am confused as to how ACE knows how to reach the Rserver subnets as they are not adjacent, as all the literature suggests that n...
Thanks Leo, however the packet loss occurs at the same time on all hosts whatever their arp-cache timers, so if I boot 2 hosts an hour apart so the arp-age is different they will both experience the packet loss at the same time.Any other suggestions ...
