Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks.I have what I think must be a simple config request, I am sure someone can solve this in no time.I have a non-cisco router with a public WAN address. This is conencted to a 3750 switch internally. The switch is the default gateway for all VL...
Hi, folks.I have an 1131 LAP that keeps dropping off the network. I have plugged it directly in to the switch but it cycles the colours as if it can't find the controller.Any tips on where to start troubleshooting ?NM
Hi Folks.I always thought that an access point (unless configured not to) would tunnel back to the controller, so would be connected to a switchport in the same VLAN as the management interface. However, if you apply smartport, it configures the port...
Hi, I would like to grab a show run-config without the breaks so I can run it through the WLC Config Analyzer. (On a side note, does anyone know where to get the WLC Config Catcher that the training video mentions ?)I can't use "config paging disable...
I have a DHCP scope as follows:ip dhcp pool native network 10.10.1.0 255.255.255.0 dns-server 192.168.4.254 default-router 10.10.1.1 lease 7I have 62 access points (not Cisco) that come up and get an IP address. It's a new install so we are dropping ...
Not sure I understand you now.The problem is solved, I gave you marks for the correct answer, I think you got 5 stars - what am I missing ?The router is a Livewire Connections FB10 Pro Rackmount.Neil
I am sorry, I wasn't sure how the rating sytem worked.I selected what I thought were correct or helpful answers, and the ratings seemed to fix themselves.Of course I appreciate your help. please tell me how to correct the rating so you feel it's fair...
Dear all, thanks for the help - my bad, I was mistakenly given the connection as UDP, I tested with TCP and it worked, the config was correct all along.:>)NM
The router is a hybrid device, quite proprietary, and nothing you would know.Actually, your answers have prompted me to check a few things, I have another port map set up to another device on another subnet and it's working, so probably the config is...
Hi, The router does provide NAT of course, for all of the routed subnets that come to it.The router is NOT cisco and has a limited feature set.The default route back to the subnet is VIA the Cisco 3750, so all traffic coming from the router goes to t...
