Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a simple question: Enabled HTTP is a must for connect Cisco Network Assistant to a switch (for example Cat3560v2) or https access is enough?thx in advance!
+1, here was the same.
8.5.120.0 solved the issue. But, of course "zombie" APs could back to life only after successful upgrade when they were connected to gigabit capable ports.
We have same problem after 8.3.140 upgrade. No MAC address is shown on interface, but links are OK, however AP says the link speed is 1000. We have 3560v2 switches with 10/100 Mbps access ports. I am sure, the problem is connected with the the OS of ...
Dear Nathanael,http server _OR_ https server needs to be enabeled?My experince was if only https (and not hte http) was enabled network assistant didn't work.
Hello!The config file is an xml file. It is describe the name of community in between and . I think it is must be same like name of the xml file. May be you renamed the xml file, isn't it?Rgds,Tivadar
