Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a IR829GW to use cellular modem for internet access which is working, However, I want the router to assign an IP address to the SMS modem connected to GE1 config below.The modem is not getting an IP address.version 15.6service times...
I have a IR829GW that was connected to a battery and the battery got drained. Now the Router wont boot up. It is stuck in a non boot up situation.There is no output on the console port and the LED's are stuck permanently on as shown in attached image...
Hi All,I have a IR829GW that has a red flashing led on the WLAN.I need to setup the WLAN for the Wi-Fi to be able to do some basic testing.Please see below the boot up process and commands used.IR829 Loader Stage 1 Version 1.8FPGA version 0x20700 bui...
I have a IR829GW that's stuck in a boot cycle before this it was erasing and reloading the biosAny help to get the router out of this boot cycle would be greatly appreciatedIR829 Loader Stage 1 Version 1.4FPGA version Reset reason: CPU reset buttonBI...
Doing a Factory Reset was one of the first things I tried. Oh well looks like I will have to get it sent away for repair. Thanks for the advice though.
Thanks Marce. I had already realised that the problem is within the AP. However, If its a software issue which I believe it is then I would like to know what to do to fix it.
I don't believe its the memory as this router was running correctly before.I have it now booting to rommon 2 so a step further. However, it still wont accept the boot from rommon 2. See below:IR829 Loader Stage 1 Version 1.4FPGA version 0x10000 built...
The file came from unzipping the bundle tried what you suggested and I got this:rommon-1> boot flash:ir800-universalk9-bundle.SPA.159-3.M3.binERROR: Image signature verification failedrommon-1>
