Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have tunnel 100 and 200 running across Site A and B, with EIGRP configured on both tunnels. Tunnel 100 is sourced from e1/0 and tunnel 200 e1/1 on both sites. The bandwidth and delay of tunnel 100 has been configured to make sure that EIGRP calcula...
I'm reviewing a configuration I came across on an organization's network switches and would like some clarification.I noticed that there was an EtherChannel between two switches—let's call them Switch A and Switch B. On Switch A, the EtherChannel was...
I need some clarification on this, I redistributed routes from EIGRP to OSPF through area 45 and it works fine. My question is, is it a best practice to redistribute into a non-backbone area rather than the backbone area?
Hi @David Ruess,I beg to differ. While it may not always be advisable, it is indeed possible to configure (or modify) the delay and bandwidth on an interface. I tested this in a lab environment, where Tunnel 100 was configured with a bandwidth of 100...
Oh no, switch A has a Layer2 etherchannel connected to switch B which has a Layer3 etherchannel. The port-channel on switch A is configured as an access port to a VLAN while that of switch B just has an IP address configured on it. The SVI on switch ...
