Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The 3750's act as one switch in stack formation. I have 3 switches stacked, and I have loaded the proper IOS on the first switch and as I begin to stack the switches the IOS is loaded to the 2 other switches as it should be. The problem is below:Swit...
This has been set up to dial back to our DBU router. Do these configs look correct. These are the errors that I am getting in the routers log.Could this be a service provider issue or a mis-config issue. Please help ASAP. I will rate. %ISDN-6-LAYER2D...
It has been a while since I have used it. But thier was an IOS cmd where you could send a note to any users in the router. Does anyone know the command. I thought that it was cisco# speak and then the note but that doesn't seem to be working for me. ...
Ok I have a standard set up I have my local pc connected to the switch. I have configured VLAN1 with an ip on the same subnet as my machine. I am able to ping. Below is the config that I placed in the router as well as the error that I received. I ha...
I have yet to do anything with .tar files. What would be the best way to place it on the switch? Do I TFTP the .tar file onto the switch?Any help woul be great. I have done IOS upgrades on all kinds of sw and rtr's but never seen this the .tar files....
It looks to be a LEC problem. The only reason I would suspect a mis-config is someone changed the config on the same day that it started having a problem. I am on the phone with the lec now trying to resolve this issue. Thank you very much for your h...
This is the layer 2 debug output that I got. Jan 23 08:24:27.855: ISDN Se2/2:23 Q921: User TX -> RRp sapi=0 tei=0 nr=126Jan 23 08:24:27.859: ISDN Se2/2:23 Q921: User RX <- RRf sapi=0 tei=0 nr=114Jan 23 08:24:28.659: ISDN Se2/3:23 Q921: User TX -> RRp...
The following is how you would complete it.router>router>enablerouter#config trouter#line vty 0 4 router#priviliage level 15router#password (then your password)router#exitrouter#wr memThen you should be good. Please rate if this helps.
