Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts! Would really appreciate any suggestions around the best approach to setup the following environment.13 environments exists with each having 4 servers e.g. 1A, 1B, 1C & 1D2A, 2B, 2C & 2D3A, 3B, 3C & 3D.....13A, 13B, 13C & 13DEach individua...
Hi Experts!I'm hoping someone might have encountered this!I have this topology;Mgmt station with ASDM -> Firewall -> Core -> FWSMmight anyone know what ports are required to be open on the Firewall in order to allow the ASDM mgmt station download new...
Hi Experts,Would greatly appreciate your comments around this topic, also any related links would be most welcome.How should the ACE distribute multiple connections from the same source under the round robin pedictor?1. should all connections be sent...
Hi,Can anyone share experiences or any info relating to issues that might be encountered when load-balancing sftp protocol?The goal is to distribute inbound file deposits evenly across SFTP servers. High-level OverviewClients -> Internet -> Tier-1 Fi...
Hi All,I have a couple of questions around the CSS 11501 would be grateful if any gurus out there cud shed more light, here goes;-Does the CSS support bridging between 2 vlans? In a similar way to the CSM. What command might be used to achieve this?T...
Hi litrentaThank you for your response!Sorry I didnt mention earlier but another key requirement is for a service failure e.g. port 20080 or 20087 should not take the entire server out of rotation i.e. it should be able to still serve for 20081-20086...
Thanks for your response Giles.Gotcha, further more ... so if CSS is L-2 adjacent to the servers do the servers have to have loopbacks created for the VIP?I wud assume this wud be required as the CSS will only be re-writting the MAC address? Can you ...
Hi Giles,Thank you for your response.I was under the impression that if redirection is being done at layer-2 (aka bridged mode) then server's need to be layer-2 adjacent with the Load-Balancer. Is this not applicable to the ACE?I would greatly apprec...
Hi I'm sure you know this is'nt a valid configuration, i dont believe you would be able to successfully have both L3 interface up at the same time.Thanks
Both, such that your trunk between cores with caryy access VLANs and VLAN4 only, and yes this link could be an etherchannel bundle preferable.You would then form the following EIGRP Adj.;C1<->C2 (over VLAN4)C1<->R1 (over VLAN2)C2<->R2 (over VLAN3)Acc...
