Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a question on prefix-list. Can someone confirm that the below prefix-list achieve the same result ? as to my understanding, both the below would achive the same result which is it matches prefixes from /23 to /32 are allowed.1) ip prefix-l...
Hi,
I have a used Cisco ASR and I cannot get into the switch. It looks to me that it either has a local username and password OR the configuration had TACACS on it.
I would like to know since its a now an offline, non-production router; if it had ...
Hi,
I have the following two questions around the working of the 3650s.
i) Can a 3650 be stacked with different 3650 models ? ie) a WS-C3650-24PD-E (PoE) and a WS-C3650-24TD-S (non-PoE).
My understanding is that this is allowed as long as the i...
Hi,
I have a Cisco 3650 running software version 03.06.03E.
I noticed that I cannot set the encapsulation to dot1q even though I have configured the port as a trunk.
------------------------------------------------------------------------------------...
Hello Experts,I have a scenario whereby the PPTP server is internet facing. Refer to the current setup.The aim is to do the new setup which is to put the PPTP server behind the Cisco ASA firewall.The way I plan to do this is as follows :-1. Create a ...
Well when I used the Cisco Power Calculator, it seems that it can run in redundant and combined mode. The FAQ on the 3650 says this as well. (Please refer to the attachment)
The issue is that I can't find the command to configure this on the switch....
Well from this URL : http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094a5a.shtml, it seems that the inspect command is only used if the PPTP client is behind the ASA box. In my setup, the PPTP client is...
Well the terminal server that I had trouble configuring works now. It was due to me not adding the Group Async interface to configure the tty lines.The doc that you presented does not address how to configure the tty lines using Group Async interface...
