Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.I have set up three access points 2x AIR-AP3802I-B-K9 and AIR-CAP3702I-A-K9 running 8.10.180.5 with one 3802i acting as ME controller + ap, while others are lightweight members. They're also members of the same AP group with single SSI...
Hello,We're unable to connect APIC-M4 to leaf's (N9K-C93180YC-FX3) uplink ports using CVR-QSFP-SFP10G adapter. We've tried converting port to downlink but it shows "out of service" status in CLI and invalid status in APIC GUI.We're really short on ac...
Hello everyone,
I wonder if it's possible to set up PBR or any other means, to route traffic back via specific
IP/next-hop
based on ingress interface.
I have an IOS-XE router with two ISP uplinks. ISP1 is a traditional PAT with
default route
and ever...
Correct, it was 8.10.185.0. Actually the problem came back bit later and after poking more, I think it was WPA3 causing problems for my android devices within range of 3702i. Once I've turned it off, then the problem went away. Roaming is not as fast...
Overall WCA liked my configuration and I had near 100% score in best practices, but it reported an error: Controller is running deferred or not recommended code and should be upgraded. Now this is very interesting, since the very same version is a su...
Just to clarify I had to use PBR on interface on which server is connected not upstream interface. Otherwise return traffic hitting router from the server will follow defroute and never "reach" PBR. This might defeat the original purpose of route man...
Thank you for the answer!I was thinking about something similar, but got confused how to construct flow logic correctly, as PBR doesn't have direction when attached to the interface. Yes I have one specific TCP port forwarded, that public clients wil...