Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2 x 6500 capable of L3 switching. On switch A, 1 routed port running OSPF. On switchB, 1 routed port running OSPF also. Both Switches are connected to a single chassis F/W capable of running OSPF routing services. On both switches, i have a ...
We just migrated one of my customer IDS 4235 from version 3.x to 4.1(1)S47 using the Ugrade/Recovery CD 4.1We are trying to apply basic configuration like changing the hostname & IP address by using the CLI command "SETUP". Everytime we apply the cha...
To all GURUsthe scenario is thisnortel pabx --vg--call mgr--ip ivrE1 CONFIG USED************controller E1 7/6************* ds0-group 1 timeslots 1-15,17-31 type fxs-ground-startProblem scenario 1, we cannot make "incoming call" running even if we use...
Hi:The same problem happened to me before. But i found the solution, w/c is you should not go to the "All signatures" category when you edit the signatures. What you need to do is to go to the 2nd level (Engines) & so on. In this way, you can edit mu...