Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,We recently upgraded our 4402 WLC to version 4.2.130.0. Since then, we have had issues where clients randomly get disconnected. Searching through this forum and online...I have found some references that suggest there may be a problem wit...
Greetings,I have a very strange issue. I have configured a 3005 concentrator with an address pool that is in the same subnet as the private interface. When I try and connect a client...I get an error stating that NO AVAIL ADDR with a further explan...
Greetings,I am seeing very strange behavior from my 2106 controller. When I load it up the firs time and run through the config wizard, everything works fine. When I then begin to configure my additional WLANS/Interfaces/Ports, it will at some poin...
Greetings,I am wondering if there is a way to disable the SSL requirements for the Web Authentication? Currently I only see options to add/create a new certificate. If there is a way to do this, please help.Thank you very much.
Greetings,I am running CCM 4.1(3)sr1. I have a situation where meet-me conference numbers are giving busy signals when users try to activate them. I can confirm that in the range of twenty numbers defined, at least four were giving busy signals whe...
Thanks. I'll definitely mention this to the engineer.Did the controller you had ever work properly? Our controller worked fine until we went to 4.2.xxx and downgrading it to 4.1.171 also returned it to a working state.
Greetings,Just wanted to update the status of this issue because it is still an issue. We recently upgraded to the latest 4.2 release. Same problem. What we are being told by Cisco is that they are seeing a lot of interference. The current theory...
Thank you for your reply.Do you know of any particular issues with RRM and 4.2.130...or perhaps it just didn't work correctly in 4.1.171?It just always bothers me when something that worked fine before a software/firmware upgrade has issues after the...
Thanks for both your reply's. I think in the other thread there may have been a typo.What started happening was that clients would be dropped from the nearest AP and then re-associate with one farther away. After a few seconds, clients would drop t...
