if you wanted to have the end-nodes use stateful DHCPv6, then the RA would contain the bits A=0
his nexus running version 6.2(16)
has the following config:
nterface Vlan175
ip flow monitor UW-IPv4-DEFAULT input
ipv6 flow monitor UW-IPv6-DEFAULT...
has anyone verified or tried this? i'm working a case and it just will not establish the neighborship.
using bgp and it's in a vrf (should be irrelevant)
the bgp neighborship comes up - the bfd neighborship does not.
thanks in advance!
nexus
versi...
hii found https://cisco.jiveon.com/docs/DOC-989049but it is dated. and the author is not in cisco directory so i also am looking for more updated feature support/not support information.tricia
with great thanks to our cs-9000 team! yay!!
customer recarved NAT TCAM to 2048
he's still monitoring and holidays = will not focus on this until january but good news so far.
thanks team! :)
tricia
i should have included:
N9K-C9372PX-E
and to clear the nat table he has to NO feature nat
then feature nat
i'm going to recreate in a lab.
9k v 7.0.3I42 - clear nat table does not clear it, has to no feature nat, then reconfigure nat ~1x per week....
my customer is getting the same error when he uses NAT
Sufficient free entries are not available in TCAM bank(3)
he's carved
hardware access-list tcam region qos 0hardware access-list tcam region vacl 256hardware access-list tcam region racl 256har...
thanks Alexsander
you're right not enough infor
the 2 devices back-to-back vpns with bfd timers in the vrf interaces and bfg in the vrf family totally worked. bgp came up as wenn show bfd neighbors came up.
when i inserted 2 nexus 9ks in between th...