Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a client supporting 802.11ax (Intel® Wi-Fi 6 AX200). In the specs it supports 2 special streams.But I can't connect it with more than 1! The test setup is a C9800-CL WLC with a 9120 AP connected. The only place I can find something you can...
Hi,I have a Flex Connect design on a new 9800 WLC.I would like to know if I can have a different VLAN ID per SSID like the AireOS FlexConnect Group - WLAN VLAN mapping. In my design the Flex Profile is equal to a Branch Office. So I would like to con...
Hi again, I found that this could be a 17.3.3 bug. Because the Current TxRateSet (m9 ss1) is not showing the right value!When I have a client connected with Current TxRateSet m9 ss1 I can see that the AP is using channel width on 80MHz.And the Client...
Hi,I know that document:)But i think that it's the Policy Profile that should be considered as a VLAN. And then when you do the Policy Tag (Branch Office) you map the WLAN to the Policy Profile (VLAN10). So if you need another Branch Offices with the...
Hi, The Flex connect is supported by the 2700 model. And the AP mode doesn't matter for the joining process.The joining process is likes this:AP sends the Discovery Request and the WLC answers with a Discovery Response.The AP will then send the Join...
