Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have configured the secondary tunnel on the Non-Meraki IPSec VPN peer but when we configured the health monitoring in the Meraki VPN peer it is showing as down. Need to know how we can configure the VPN tunnel failover if any of the ISP on the oth...
We have a FPR 1140 which is managed by FMC. Also have 3 ISP on it. Now we have configured RA VPN on all three interfaces. We are using 3 outside interfaces and for them 3 fqdn like vpn1.example.com vpn2.example.com vpn3.example.com. And the sequence ...
I have a FPR 1140 managed by FDM. We have 2 ISP and I want youtube traffic to pass from ISP2 and all other internet traffic from ISP1. How can I achieve this?
We have ordered C9300 switch with advantage license and MS130 switch with essential license. Can we add both the devices with their licenses in the same organization.
The Meraki TAC engineer said that the health check will be done only for the public IP/domain where it should be reachable from that tunnel only. So it seems Meraki dosen't have a failover solution for the non-Meraki IPSEC VPN tunnel where we create ...
Hi @alessandrodematos can we do the http probe check for the private IP which is reachable from tunnel or will have to do http probe for the public IP only.
Thanks Alessandro for the document. But when we configure health check will run if the firewall is in passthrough mode. But we are using firewall in the routed mode. So will our health check work?
