Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have ASA5510 in transparent mode with just one BVI interface connected to 2960 switches via an access port.
SW1 SW2
| |
ASA1 ------ ASA2
| |
SW3 SW4
Now I'm going to add two m...
Hi All,
Can anyone advise what is the best and most secure way of setting up a remote (SSH) connection to an edge router from the LAN with having dual firewalls in the way (Checkpoint and ASA) ?
RT1 --- RT2
| |
SW1 ...
Hi All,
I was doing maintenance last week and caused an internet outage so I'm hoping that someone will be able to assist ?
SW1 & SW2 are 3com 4500 connected together via a single cable via hybrid port and vlan 501 tagged and 1 untagged
SW1 & SW2 ar...
Hi all.
I was trying to send my first post into the Cisco Support Community.
Went to publish my post and I got: Your submission has triggered the spam filter and will not be accepted. If you feel this is in error, please report that you are blocked.
...
Guys,
I have a similar problem on my 5510s (ASA Version 9.1(7)16 )
The difference is that mine ASAs are in transparent mode and have 3BVIs.
On the Primary ASA two of the BVIs interfaces are Normal(Monitored) but of them is constantly being test...
Julio,
Would you know what vlan needs to be untagged on the trunk port connected to transparent ASA ?
I have ran the SSH/mgmt connection through the transparent ASA which is configured under a VLAN and one of the ASA BVI interfaces. Once ssh traffic ...
I think mahesh18 is asking for how to see tcp connections going through the ASR router (to the firewall).
In that case you can try debug tcp commands.
From top of my head there should be debug tcp transations, packets and few others. You can specify ...
Hi Muraripadhan,
It's quite basic networking level question but my assumption it's that you know the basic networking stuff (you know what VLAN is, etc.) and you're just confused.
Native vlan (by default vlan 1 & it's recommended to change that vlan...
I'm going to use this solution then. Until I figure out how to allow Radius traffic on our transparent ASA I will probably use just a local admin.
Do you maybe know if I have ISR4331 with IP address to its mgmt interface which apparently it's a separ...
