Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm running Cisco ISE 3.3 with CWA for Self-registration guest portal. When a guest connects to the SSID, they receive the error below. I followed the https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers...
Hi all,I’m relatively new to Cisco ISE, and I’m running into a profiling challenge I could use some help with.We have an existing deployment of Device A that authenticates via MAB and is correctly profiled using a custom policy. I’ve now been tasked ...
Hello,I setup a test alarm notification in vManage using the option for Webhook so that we can be notified when a TLOC goes up/down or BGP peer state changes. I added the Incoming Webhook to teams but still no luck. Any advice would be greatly apprec...
Hello,I recently connected a new CW9166i-B access point and it's stuck flashing red & green. It successfully authenticates via ISE, gets and IP address but doesn't show up on the WLC. I can ping the IP from the WLC and ping the WLC from the switch. B...
thanks for the reply.I found out that I had to add the correct profile to the authorization policy. For the conditions I used dhcp_host-name matching ^device A-1234.*Thanks for your help -
Thanks for the reply. I added an additional condition using DHCP hostname for the condition. When I run sh auth sess it shows the Device-Type as Un-classified and Status- Unauthorized.
