Hellooo
to elimitate Vlan 1 is not possible, so in order to change the IP address you can access to the switch via console port and execute the follow commands
>enable
#conf t
#interface vlan 1
#ip address (the ip address that you would like)
# no s...
hello
unfortunately 200 series of switches dont have DHCP Server feature. The 300 and higher are DHCP server optionally on them, but the 200 do not since it's just a layer 2 switch.
Greetings!
Hi, about the bug, Jabber for Windows queries the file c:\dev\urandom during operation. /dev/urandom is the random number seed file on unix systems, however it is not a file that is normally present on the windows platform. Random numbers are normall...
Hi!
A vulnerability in how DLL files are loaded with Cisco AnyConnect Secure Mobility Client for Windows could allow an authenticated, local attacker to install and run an executable file with privileges equivalent to the Microsoft Windows SYSTEM acc...
Hi,
I share you the commands tha you need for your switch
Switch(config-if)#switchport trunk allowed vlan ( vlans that you want to permit)
Switch(config-if)#switchport trunk native vlan (vlan that you want set aside as native)
Greetings!!
