Using Cisco 800 router and using the DHCP windows server , and want to configure the mac filter that any static IP user cannot pass through the router or can get access for internet
Hi,
I there anyone can help me on this..
Cisco C881G-4G-GA-K9 (revision 1.0)
Cisco IOS Software, C800 Software (C800-UNIVERSALK9-M), Version 15.4(3)M4
ERFLOW: Dialer0: the fragment table has reached its maximum threshold 16000269: *Jul 2 08:22:02.9...
HI,
Hope someone can help me on this.
I have a small remote office network installation and the internet is blocked for all users, and from there i got a request that one user require access to the internet for specific website, please guide me how ...
Dear @balaji.bandi thank you for your advice, in the current infrastructure we are not using aruba switches, we have cisco 4G router and the Windows DHCP server with mac filter, I don't want any device to configure the static IP and access my netw...
Dear @hslai Thank you so much for your suggestion, but i don't want to configure anything in the router, at one site we are using Aruba Access point, with the same scenario and there we are using DHCP enforcement in Aruba Wifi Access Point, which id...
Dear Balaji, Thank you for your suggestion, but here am looking like only mac filter let me clear the scenario for you, We are using Cisco 800 4g router with the Windows DHCP server ( Mac address Blocker @ Windows DHCP End), its working fine, but n...
hope you can help me
facing the same issue in Cisco WS-C3560-48TS-S
LQZNL-OFFICE-SW#show errdisable dALQZNL-OFFICE-SW#show errdisable detectErrDisable Reason Detection Mode----------------- --------- ----arp-inspection Enabled portbpduguard Enabled...
hi for the second command the below message
Warning: When Cisco determines that a fault or defect can be traced tothe use of third-party transceivers installed by a customer or reseller,then, at Cisco's discretion, Cisco may withhold support under ...
