Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First off, I have to say I am EXTREMELY dissatisfied with Cisco's supposed support. I just bought this device and it is not connecting. I did the usual google searches and nothing helps. I watched the Tech Talk videos and followed the directions w...
Does the CB150-AX, in its factory state, tag its traffic with VLAN ID 1 when it is first configured or is the traffic untagged?I'm trying to configure a CB150-AX with a Juniper EX 2200C and I need to know if I configure a trunk port at the outset, do...
Just for completeness, here is the working config on the port fro my Juniper EX 2200C.{master:0}[edit interfaces ge-0/0/2]
root@EX-2200C-Upstairs# show
description Cisco-AP;
unit 0 {
family ethernet-switching {
port-mode trunk;
vl...
Thanks for the doc, but I can get past that part. It is when I enable VLANs on the AP that I have issues. As long as the AP is plugged into a VLAN other than VLAN 1, it works fine. The problem comes in when I setup the VLANs and then try and move ...
