Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does the 150AX support WPA3-OWE (Enhanced Open)? It's essentially an 9105AXI (ap1g8) with a modified version of EWC, correct? The 9105AXI does support OWE, but I can't find anything about the 150AX.We currently use 1815i APs with Mobility Expre...
I'm trying to connect an HP Laser 107w printer to an Aironet 1815i AP. The AP is running latest Mobility Express Firmware 8.10.151.0. The WLAN is configured with basic settings (WPA2 PSK). The printer won't connect. Other devices have no issues conne...
I'm using the Cisco Wireless Android app to monitor a Mobility Express system. This worked fine with all ME versions up to 8.8.111.0.After updating ME to 8.8.120.0 the app won't connect any more. Error message: "Please enter valid credentials."The cr...
I use a WPA2-PSK SSID for IoT devices which don't support 802.1X. Now some of those devices need to be moved to a separate VLAN. Can this be done with Mobility Express (8.8.100.0) without creating yet another SSID? I'm thinking about MAC-to-VLAN mapp...
The CBW APs only require a DHCP server for initial setup. After that, you can configure static IP addresses. Be aware that you have to configure two static IP addresses: One for the AP and one for the embedded controller ("primary AP"). If you only c...
You have to change the native VLAN ID on the CBW150AX to something other than 1 (Wireless Settings / Access Points / Global AP Configuration). Whatever VLAN ID is configured there will never get tagged, even if configured otherwise in a WLAN.I did ch...
The management traffic of these APs is never tagged. You need to configure your desired management VLAN ID as native on both the switch port and the AP (Wireless Settings / Access Points / Global AP Configuration).
Did you check whether the mesh extender's MAC address was added to the local MAC addresses allowlist on the primary AP? You might have to do this manually.
