Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Quick question. I am going to be prepping a 9500 stack and was curious if I did the initial config using some 100G dac cables to build the svl link I have in office but then the tech installing the switch used 40G qsfps for it, would that cause any i...
Hello,
We have integrated ServiceNow with Catalyst Center and are getting issues and tickets created just fine. But every now and then we get a incident created that has no info at in it, and it says it was closed by caller. I am assuming this mean...
Hello, I am trying to get a user defined issue to trigger a email notification. I can get a email notification on the base system ones like a interface going down or ospf adj with no issues. But when I try and do one for a user created one I do not g...
I know that you can pull certain system variables from a device and use those as variables and what not, but is it possible for a DNAC template to essentially parse a running config and then pull a value from it? Like what the AS number is if the dev...
Hopefully this is a right place to ask this but I was wondering if there is a way to have a user defined values for a Jinja definition in Dnac. Say I need a dynamic amount of 3 values being ip address, mask and dot1q tag to create sub-interfaces but ...
@AshSe Thanks appreciate the response! This may be a dumb question but I would assume there is no way to preconfigure the link and stack without having the two switches connected to each other?
Sadly not. There is no data at all in ServiceNow just an incident number. I did notice that the issues/events that are properly being created in ServiceNow, the incident number is not being corrleated back to the issue in DNAC. I did notice that they...
Here is a screenshot of the full message. Currently on version 4.0.0.91. I heard the SB350 Switches can have this issue as well, which also dont run the normal Cisco IOS firmware's so not sure if that is related at all
