Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running a c3640 at home with 2 connections. 1 connection cable(charter communications, dynamic ip and outside nat interface) and Bell dsl(static). I'm currently routing certain traffic over the adsl line to the office and the non-office traffic...
Hey guys, I have a customer that has two links between them (3640) and my router (7206). One connection is via wireless using proxim ptp. The second connection is T1 primarily used for backup. The wireless F0/0(3640) link is preferred since they ar...
Hey everyone, just wanted to ask a couple of questions here before I make a purchase on a pix515e.Unfortunely we have close to 130 MS machines that are repeatedly getting infected with worms/trojans etc. What I would like to do is just block all out...
Hey guys, I upgraded my IOS this morning so that I can enable ssh server. I have ssh configured and am able to establish a connection via ssh. My question is, how do I disable telnet?Thanks in advance,Troy
Over the past couple of weeks I've had numerous problems pop-up when we relocated our office and changed upstream providers. Most of those problems have been addressed and fixed. However, I still seem to have an ongoing problem that I do not know ...
I've tried just about everything last night and I do appreciate your time in helping with this issue. I'll paste my config below. I want to explain what I'm trying to do here once you see my different static routes.I live in the affected area from ...
thanks for the reply hank, I dug a bit deeper and found that I was using an older nm1e2w module instead of the 1fe2w modules. I now have the atm interface but am having problems with the config to get this line up. I called up bellsouth to get my v...
On the 7206 i do not have any static default routes because of running bgp with my upstreams. any other way around this possibly using Floating Summary Routes? i've run eigrp before between several routers but those routers always had default route...
Sure I'll post the config at the bottom of this message. I had previously wiped the config to start from scratch to make sure I didnt have anything in the config that would cause this problem. This routers F5/0 is plugged directly into a machine ju...
