Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have Catalyst Center v2.3.7.7 for our catalyst 9300/9400/9500 switches.Occasionally, we have to deploy a new switch where no dhcp server is available.For such case(in which we have to manually configure static ip on new switch on vlan1 inte...
Hello,With IBNS2.0, I'm looking for a way to apply different service template(s) per radius attribute (specifically custom cisco-av-pair) given by the server. Is there any configuration example anyone can show for better understanding?Thank you in ad...
I used to change device values from Vmanage by navigating through configuration > Devices > click on three dots far right side for a specific device(DeviceA for example) > change device value.Recently, I found similar option under configuration > Tem...
Preston, Thank you that works like it should.I did try using https over 443 which didn't work and realize that it initially communicate with CatC over unsecured channel first. Again, Thank you!
There is a default interface template contains most of basic configuration for dot1x to work correctly so all interfaces will have minimal line of config which is static. I would like to use following event under policy map, to activate different ser...
Arne, Thank you for your reply.What I'm hoping to do is to run(activate) different service template against interface depending on which device profile endpoint belong to. Is it possible to use service template name from ISE that matches with one on ...
