Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I just spent 3 hours with TAC getting no where, but my problem seems simple.Topology is below.Each host has a primary VLAN (V1 and V2) with a default GW towards the Nexus, and a common VLAN (V3) between them---- V1 |----| V2 ---- | A |----| ...
Hi all, I am attempting to boot a host over iSCSI but have run into a brick wall trying to get my host to boot after successfull install of the OS.Without changing the service profile I am able to install and boot VMWare ESX fine. Windows just does...
Hi all, I am starting out my IPv6 knowledge as my ISP has started provding IPv6 services over 6RD.I have a router which does my DSL and internet facing NAT, then behind it I have an additional router without DSL that I do all my other stuff on like ...
Hi all, I have two questions:1. Does the 6248 support SFPs such as a GLC-T?2. I am aware that the 6428 support two upstream layer 2 domains by pining certain VLANs to port groups which are attached to differing layer 2 domains, but does this princip...
Hi all, There is nothing which outlays the effect of doing an ISSU on the FEXs within either of the following configuration guides:* Cisco Nexus 2000 Series Fabric Extender Software Configuration Guide* Cisco Nexus 7000 Series NX-OS High Availabilit...
Hi all, Bit of an update. It turns out M2 line cards are unable to mark DSCP values. If you put a set DSCP statement in your policy map, it marks the equivelent CoS value.This becomes a bit of an issue when you use OTV as it only used the DSCP val...
There is no problem with matching traffic, as I said in the original post, under both situations the policy map counters increase on the correct class. If the packet is routed by the Nexus, remark happens, if it is switched, there is no modification...
Neno, 1. A and B are B200M2s in a UCS environment running CentOS 6, one is pinned to Fab A (Po10), the other to Fab B (Po11) 2. Yeah, all VLANs are through the Nexus 3 & 4. Configs below!Command: show running-config interface port-channel10-11!...
Now it gets even stranger. As suspected the configuration is correct as I now have it booting into windows.The strange part is, all was working ok until I applied all current updates, then it went into windows recovery mode and can't find my partiti...
