Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I would like to know if there is some laboratory or emulator to test this kind of switches. In fact, I would like to test Port Channel, Fabric Path, Quality of Service, Security, Users, Events, Troubleshoting, etc.
Do you know some guide or...
Hello, I don't know how can I check the memory usage in my switch 2960S. I checked with "show version" that the switch has 128 MB of memory. However, I see with "show memory" that the whole total memory between Processor, I/O and Driver is less than ...
Hello,I have a PIX firewall with inside, outside, dmz1 and dmz2 interface.nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 dmz1 security80nameif ethernet3 dmz2 security70I can run icmp echo request from inside to ...
Hello,I would like to know if I can use management interface as firewalling interface like Outside, Inside and DMZ interfaces instead of just out of band interface.I have a Cisco ASA.Thanks a lot, best regards.
Hello Raj,
thanks for your reply.
I have been googling VIRL but I have seen that it is mainly for routing purpose instead of switching while I don't know if GNS3 could be used for switching purpose.
With regard to documentation maybe some CCNA cer...
Hello Madhu, First of all, thanks for the information. It seems that although the switch has 128 MB of DRAM, the memory proccessor has only 64 MB, plus 14 MB of I/O and 1 MB of "Driver te". Therefore, I suppose that the remaining memory is for system...
Hi Jon,The security level are:nameif ethernet1 inside security100nameif ethernet2 dmz1 security80nameif ethernet3 dmz2 security70It's weird because if I run icmp echo from 192.168.1.0 to 192.168.2.0, later I can run icmp echo request from 192.168.2.0...
