Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have a question. Have a configure trunk interface gi1/0/48 and connect with cisco 4507 interface 1/47, but don´t up,when a run command sh int gi1/0/48 show me down down not connect, change the cable and same result. but connect beetwen two switc...
Hola.Tengo un enlace L2L en fibra optica, para fines de prueba lo conecte a un sw 3750 metro y levanta sin problemas, incluso acceden al sw remotamente. Cuando lo conecto a un sw 4500 y a un 2960 no levanta el enlace L2L. Y cuando conecto el 4500 al ...
Hi,I configure asa5520 with pppoe authentication. The service provider give a Static IP Address,but I test the asa can´t ping outside IP address and can´t open port from internet server in the inside.
Hi, thanks.The ios image is the same above mention.attach file with the outputs of commands. And is a port RJ45 on the switch, this switch have 2 uplinks for 10G.
hi, thanks.yes, but change in both interfaces to duplex full and speed 1000 minutes ago, and the same result, down down notconnect. We probe connect beetwen 2960x with 2960S same result down down notconnect, only connect beetwen 2960X the interface i...
Hi, the problem persist, so i send the information generated when the problem ocurrs.1. Add file with the e-mail alert, the display when run "show process mem" from CLI of box, and information when run snmpwalk from ciscoworks>devicemanager, and the...
