Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello together,currenty I've an old ISE 2.7 integrated (standalone) in my CatC v.3.1.6.The ISE need to replaced with a pair (active/standby) that are at version 3.4. So I found this guide:reintegration guide ciscoIn this Guide it is described how I d...
Hello together,I've a question about bgp routing in my CatalystCenter Setup.I want to achive that there is a second way for my 'VN_Test' to a separate bgp peering point.Becaus if I had any problme with my C9600 I got lost my connectivity for 'VN_Test...
Hello together,today I've a new question and hope again that somone can explain some things.I create a litte draw and attached it. At this point our VN is terminated from two border nodes (BN) to one router outside SDA.I want to add a second router o...
Hello together,today I want to ask you if somone please can help me to solve the following error message in my CC:Suddenly a few devices in inventory view shows me that they are no longer compliant.OK I click on "Non-Compliant" and saw 1 open violati...
Hello together,today I think I've a simple question but I'm not very sure if it is best practice so so I hope someone can help.In CC GUI I go to my BN, enable L3 Handoff and enter the local and peer IP.In field of peer IP, is it clever to enter an IP...
Hello,I mean the first option could work but with more preperation.The second one could work too but don't know..1st)I delete all SGT bindings to any manual configured port and remove all bindings to any Anycast Gateway. When done, I'm safe to start ...
Hey Torbjørn,thanks for your quick answer!The problem is that I can't integrate new ISE with version 3.4 into the existing ISE with version 2.7.Or does that work in any way?
Hey,I want so say thanks @swscco001 because we had the same problem.We investigate too that there are no way to restart a single port at the standby device.So we restart the secondary and all are fine.Our situation was a change from an older switch t...
