Dear all,
CSSM SLP supports Smart/Callhome type and SL supports Callhome type only so currently two CSSM servers are functioning.However I think the following condition, "telnet tools.cisco.com 443 /ipv4" shows "Bad IP address" and it takes more than...
Dear all,
It is pretty curious if it configures below and after ping Nexus9K creates AM route. I appreciate if there is any speficiation or tips.
interface Ethernet1/3
medium p2p
ip unnumbered loopback0
ip ospf network point-to-point
ip...
Dear all,
I have two questions about invalid-spi-recovery mechanism below.
1. According to the following URL, in my understanding "crypto isakmp invalid-spi-recovery" command is just a work arround because this command itself does not resolve the inv...
Dear all,
According to the folloiwng output, I think Catalyst8500's CDP is disabled on interface level by default right?
Cat85(config)#cdp run
Cat85(config)#end
Cat85#sh cdp interface gigabitEthernet 0/0/0
CDP is not enabled on interface Gigabit...
Hi thank you for your info. Both is Fixed version however... if the folloiwng devices are compared wth same cdp command.
C8300-2N2S-6T - IOS-XE-Ver.17.6.1aC8500L-8S4X - IOS-XE-Ver.17.6.3a
Cat83-17.06.01a#sh cdp interface gigabitEthernet 0/0/0
Gig...
Hi shehab320
> EIGRP AD 90 is preferred over OSPF 110
I think the received route is EIGRP External so AD is 170, Comparing them OSPF 110 preferd over EIGRP AD 170 right?Do you think the routing AD preference is same specification between legacy IOS ...
Hi M02@rt37 and @Joseph W. Doherty
Thank you for your precious comment! Basically FEC is mandatory however it isespecially for longer links with optical but for shorter copper links is optional right?
And please let me make sure of "100GBASE-LR4" men...
Hi M02@rt37,
Thank you for your information. I have a question about which version can configure "ip dhcp relay address"? I appreciate if you can let me know the IOS-XE Version and H/W like ISR4K 1K or ASR1K etc..
Regards,
Masanobu Hiyoshi