Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi support,I have a few questions regarding Passive ID and Easy connect in cisco ISE 3.21. In Cisco ISE 3.2 we have a Passive ID integration, Also under the Authorization profiles, we have "passive id tracking" check box enabled. According to what I ...
Hi All,we are having a cisco 8200 router running 17.09.04a and we want to configure dot1.x and mab configuration in the celular interface.I have followed the below guide in configuring Cisco Catalyst 8300 and Catalyst 8200 Series Edge Platforms Softw...
Hi support,we have done one offline cisco smart licensing for new Cisco 1121 device. Once we are done with the licensing , we are getting (-1) insufficient licenses message under "Cisco 1100 Series with 8 LAN Ports, Security License" section. If we a...
Hi teamwe have 1127-8PLTEP which needs to be licenseed. It is running 17.09.03a software code now. I just want to confirm if this model supports smart licensing ? if not to which version should I downgrade this to get the support for traditional lice...
Hi , Planning to upgrade cisco C9500-32QC models switches from 16.12.03a to 17.12.3, May I know if I can do a direct upgrade in this situation ? or do I have to go with an intermediate upgrade.in the release note document I can find only the followin...
Hi Balaji,Thank you for getting back, sorry for my mistake in explanation.our plan is to migrate the configuration from the existing cisco 1921 to new 8200 router.we have an interface configuration in existing 1900 router where it has following dot1....
Thank you for getting back, I think that is the case ,1127 only supports 16.10.x and above, so we have to anyway go for smart license. supported hardare list for 16.9.x doesn't have 1127 listed.I was initially confused as we have already had traditio...
To install the traditional license, we've tried to downgrade the version to 16.9.x but we are getting the following error in downgrading.Error: Package does not support PID:C1127-8PLTEPFailed to boot file bootflash:c1100-universalk9_ias.16.09.08.SPA....
Thank You very much for getting back.I have a traditional license file for this device, does that means I have to downgrade the software version to below 16.10.x to install the traditional licenses ?If I am to still use 17.09.03a version and want to ...
