Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
I am working on 5508 cisco WLC, and I can not access WLC with SSH or GUI when I enable LAG,
when LAG is disabled, the GUI and SSH access works fine.
I am running the software version : 8.5.120.0.
thanks in advance
Hi All,
Cisco AP 2802I-I-K9, AP Running Image 8.2.141.0, Couldn't joint with WLC-2504 software version 8.2.141.0.But AP 2602I,1702I and 3602I can register with WLC and working fine. getting below error from the AP2802I
[*04/20/2017 08:02:34.7021] ...
Hi,
find below the configuration on the switch side :
interface Port-channel2 switchport trunk encapsulation dot1q switchport mode trunk spanning-tree portfast trunkendSW#SW#sh run int Gi1/0/10 Building configuration...Current configuration : 126...
Hi,
the problem was caused by a regulatory domain mismatch as you said.
you have to add the country that supports -I regulatory domain on the WLC configuration.
thanks a lot guys.
Marouane.
Hi patoberli,
thanks for your response, i will check the Regularity domain with our Presales service.
please find attached the output that demanded.
best regards.
MArouane
Hi Sandeep,
i already upgrade the WLC to the version 8.2.151.0, it didn't help and the problem still the same.
please find attached the outputs that you demanded.
thank you.
