Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do I set up Telnet on a switch? I thought that I had set it up but for some reason it is not working. Can you give me step by step instructions to set remote access to the switch?
Also you mentioned the trunk interface. this confused me as well. When I set up the switch and connected the interface which i believe is 49, it just started working via the fiber. I did not set up the trunk but all the AP's and devices are workin...
So the switch is in an IDF off of one of the wings of the building. the swtich supports wireless AP's and desktops. It is connected back to our core blade switch via fiber. The AP's and desktops work just fine and have no problems connecting. I h...
No, can't ping it either. just comes back unreachable. Interface0 was not set up until i read through the link you sent me. I set it up off of the instructions on the page. And reading through it, it actually made sense. So VLAN1 should be set u...
Yes I am using the 200 as the telnet address.
I'm a bit of a noob for Cisco but when i was setting the switch up i read that to set up the address of the switch you have to do that on VLAN1 so what is the difference between the interface0 and VLAN1...
