Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently replaced the customer's C2960S switch with the C1000 and C1000FE switches.Many RFID devices are connected to the C1000 switch.RFID devices have been disconnected more than once or twice a day since the switch was replaced.After the connect...
Thank you for your opinion.
The case is currently being opened through the Cisco Tac team.But I can't ask my personal thoughts and guesses at will, so I write in the community like this.
According to the document, C2960- and C2960+ switches that had ...
There is no up-down log for the interface to which the RFID device is connected.However, even now, the disconnect occurs more than once a day.We also checked the status of the interface on the C1000 switch to which the RFID device is connected, but t...
Thank you for your reply.From the [show interfaces counters error] commandAlign-Err, FCS-Err, Runts, giants[The above four items have a direct effect on the value of CRC ERROR] Can I interpret it as that?My first question was misleading, but it's the...
I agree with and thank you for your charming command.My client is already monitoring the network through the use of Network Management System (NMS).However, I was just wondering what I should focus on assuming that I have to check the CRC error with ...
Align-Err, FCS-Err, Runts
If the number goes up among the three displayed items,Can I think that a CRC error has occurred?After that, should we proceed by checking the interface?Of course, I know that it is accurate to see the interface information...
