HejI am planning to deploy Inband Management plane protection to our ASR9000 series devices. I had a few questions1) Can I configure Loopback interfaces for management plane protection. Is it only for physical interfaces or subinterfaces that belong ...
HejWe are testing BNG on ASR9903 (7.11.1). We setup a radius server and want to do a test for a user, but when I do the test radius command I see it uses a different port (1645-1646) instead of the configured ports 1812-1813. Do you guys know what ca...
HejI am trying to configure DHCP pool for a vrf but I get the below error. I am not sure why I am getting the errorASR9903 - 7.11.1ErrorSpoiler% Failed to commit one or more configuration items during a pseudo-atomic operation. All changes made have ...
HejNCS540 version 7.11.2I am trying to configure a DHCP pool but get the below error regardless of what address subnet I configure. Can anyone spot the error?+++++++++++++++++++++++++++++CONFIGpool vrf default ipv4 IPV4_DHCPnetwork 172.16.255.0/24add...
HejWe have a setup where I need to use one of the physical interfaces to connect the FMC. But I can not figure out how to configure a normal port on FTD cli, only management interface.I have only console access to the device so I can not use FTD gui....
No we are not adding vrf to the dhcp setting only to the pool. In big picture this is for BNG setup so defining vrf under DHCP is not needed in XR. We are in early testings now and I was just testing with the prefixes. We will probably use multiple p...
That is for default table, if I have pools for default table with basically same config, but just says vrf default, and they commit no problem. The problem is if I try to configure a pool for the vrf unfortunately.
