Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It seems that in order to execute RESTCONF queries against the WLC, a user with admin access (privilege level 15) is required. Is this true? In order to execute read-only get queries against the WLC, you need an admin user?
I have a lab set up with a C9130-AXI AP joined to a C9800 WLC. I am trying to use NETCONF or RESTCONF to fetch device probes of the wireless network. I can get them just fine using RESTCONF, as long as the device does not have a randomized MAC addr...
I get the following failure on the console of the AP when trying to join a C9800-CL WLC: [*08/18/2023 17:25:10.9392] CAPWAP State: Discovery
[*08/18/2023 17:25:10.9417] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*08/18/202...
I'm setting up a lab to do some research on the C9130AXI-B wireless access point. As I understand it, I cannot do anything with the AP without a wireless controller, so I'm now trying to install that.I've downloaded C9800-CL-universalk9.17.09.03.iso...
FOUND IT!@Rich R 's solution wasn't exactly a fix, since I had no trouble _connecting_ using a randomized mac, I only had trouble seeing the probe requests. But this did point me in the right direction.Turns out it IS a WLC setting: WLC#config termi...
> DST doesn't matter, as long as NTP is in sync.It seems that setting the time correctly doesn't matter, it needs to have a valid connection to a valid NTP server. Once that was set correctly (even to one running in my local test network), it seemed...
> Did you check the time setup on WLC, below indicating time sync issue of your WLCI have checked it, but I'll check again. Maybe I put in daylight saving time wrong or something.> Any operational reason(s) for the need to continue using a widely-k...
Thank you. I will go back to my client to tell them they have purchased a 1000 USD useless piece of plastic and recommend they avoid buying Cisco products again.
