Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering what could have been causing my CPU usage to be consistently above 90%. I monitored using the "sh process cpu history". I had recently configured SSH as a means to remotely access router(2611) running c2600-ik9o3s3-mz.123-1a.bin. I us...
I was wondering what could have been causing my CPU usage to be consistently above 90%. I monitored using the "sh process cpu history". I had recently configured SSH as a means to remotely access router(2611) running c2600-ik9o3s3-mz.123-1a.bin. I us...
I have a 3640 with two 8mb flash cards (one in each pcmcia slot) that I would like to partition into one 16mb flash to fit IOS into. Is this possible? Thanks in advance.
I am going to upgrade a ws-3524-xl's ios and was wondering about a file contained in flash 3 ---x 82470 Jun 24 1999 01:57:32 c3500XL-diag-mz-112.8.2-SA6. I am under the impression that this file is only used at factory to test switch before it ...
Pix 515 not recognizing 128mb may be due to, I believe pix-515 supports 64mb. Pix-515e may support 128mb. Now the Pix error in not reading enough flash I did get the same message when I tried to load 7.0 release using the tftp method with an inside i...
from the console port login using hyperterminal or any other comms s/w. if required (good security) enter password type "enable" may ask for another password (good security). Then type "configure terminal" should get the hostname(config)# prompt. sim...
I am not 100% however try NO set prompt or I believe the "set prompt " will work if left blank after prompt. HTH I will await reply's from others that may be sure.
Please check your IOS version, I believe that the 12.1 & above should work and 12.2 version positively works since that is what is used in mine. Also may check what is amount of dram & flash. This message appears to be coming upon initial bootup, I o...
