Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
We would like to set up jumbo frames between a cisco 2960 and a cisco 3850.
On the 2960 :
2960#show system mtu
System MTU size is 1500 bytesSystem Jumbo MTU size is 9198 bytesSystem Alternate MTU size is 1500 bytesRouting MTU ...
Hi all,
We would like to reboot every member of our 3850 stack (6 members). Here is the current state :
1- Master
2- Standby
3- Member
4- Member
5- Member
6- Member
The goal is to reload them one by one. What is the preferable order to do this whi...
Hello all,
I need to re-create a Windows DHCP server config on a 3850 switches stack. No problem for scopes without vendor specific options but I need some help for the VOIP phones scope :
On the Windows DHCP server, I have several options with Ven...
Hello everyone,
Right now we have a branch office with two APs connected to a WLC on central site. 2 SSIDs are broadcasted (one corporate, one guest)
The APs have a static address and the clients are getting an address from a DHCP in central site wh...
Hi Rick,
Thanks a lot for your answer. I think it's the way we tested it that was wrong. We tested from the server by pinging this way :
ping x.x.x.x -l 9000
ping x.x.x.x -f -l 9000 was giving :
Packet needs to be fragmented but DF set
ping...
Julio,
Ok, so before reloading any switch I will set the priority numbers as 8,7,6,5,4,3.
I would like to avoid restarting the entire stack because of the downtime...
Isn't it better to start by reloading the Master ? Then the standby so the first ...
Hi Julio,
Thanks a lot for your answer. There is just something i'm afraid of though :
Let's say I just reloaded the 6th and I need to reload the 5th.
The moment it goes down, the 6th won't take the number 5 of the stack and get interfaces numbers ...
Yes, that's what we did at first but for some reason we have to do SNAT on the HQ firewall, and when the DHCP receives requests with a different source address it does not work...
So I think my only options are DHCP on the switch or on the local fir...
