Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
when I configure a subinterface of the interface fastethernet 0/1 in router 2621 ,it is error ,as follow:"Router(config-subif)#ip address 210.37.16.16 255.255.255.0 Configuring IP routing on a LAN subinterface is only allowed if thatsubinterface is ...
A interface fastethernet 0/1 (ip:210.37.16.1)of router 2621 link to a switch with 4 vlan ,another interface f0/0 (ip:210.37.29.1)link to the center switch .how to configure 2621?
The router 2621(interface f0/1)link to the switch that has 4 vlans , and anther interface(f0/0) link to another switch that is output .q£ºhow to configure subinerface in the 2621 (ios 12.2(8)t5?
environment £ºtrere is a router2651(Async/Sync Serial WAN Interface Card) and the intarnet,question:when mobile workers with vpn software connect to center router2651 , how do we configure the router2651 ,and do we need a hardware ,example£ºaccess...
environment £ºcenter£ºrouter2651(Async/Sync Serial WAN Interface Card)question:when mobile workers with vpn software connect center router2651 , how do we configure router2651,and do we need a hardware ,example£ºaccess server.thanks for all
there was a net . as follows :-------the switchA --------------vlan 4:166.0.16.254/24 | __|____|____|__--|----------(hosta:166.0.16.5/24) vlan 3:166.0.17.254/24 | __|____|____|__--|----------(hostb:166.0.17.5/24) vlan 2:166.0.18.254/24 | __|_...
yes,I configure subinterfaces .and I do all as you ,but there is not the "encapsulation "commandas follows:2621#config2621(config)#interface fas 0/1.12621(config-subif)#?Interface configuration commands: arp Set arp type (arpa, probe, s...
