Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have hopefully simple questions regarding multicast behavior on 3560g switches.My scenario is that i have two switches (3560g) with version 12.2 running.They both have the same setup, vlan 10 on int0/1 - 12, trunkport is int gi0/23. The trun...
Hello. We use some devices wich are able to transmit uncompressed audio. The protocol is Dante by Audinate.The protocol can send data via unicast and multicast, if more devices are feed with the same stream. The multicast mode uses the Site Local Sco...
Hello.
I have the simple question if a etherchannel (LACP or PAgP) with 2 links can switch seamlessly to
the other link if one fails?
By seamless i mean in a few milliseconds, that no drop out by a voip stream would be hearable.
thank you in adv...
Hello
I have a maybe unusual case.
I have a catalyst 3750g switch with 3 vlans on it. Vlan 1 (native), Vlan 10 and Vlan 20.
On Vlan 10 i have a AIRSAP 702.
My goal is to monitor syslogs and some snmp data from both devices.
i use PRTG for that.
On...
Hello
I'm new here.
I have an issue, that a SG200-08P device always obtains power over the ethernet connection.
I have a SG300-10P switch let's say as a main switch.
Then i have situations where i need to connect 2 sg200-08p in daisy chain to one s...
Hey Georg.Thanks again for the clarification. I will keep that in my mind maybe for the next time since deactivating the querier on one switch was a acceptable solution. Regards, Benjamin
Hey Paul.Thanks for the hint. Allthouth it did clear the issues on my site now but one question still remains;Shouldn't the querier election do exactly that? So that there remains only one active querier in the layer 2 topology. I mean in my eyes it ...
Hey George.When looking at the config of the .75 by copy pasting it, i noticed again that i set the "ip igmp snooping querier" global command.I tried it now without the switch participating the querier election and this seems to solve the problem. No...
See the configs in the attachment.I also attached a jpeg of the pim options i have. There is no option for DR. I'm absolutely not familiar with the pim protocol, since in our environment there is never a router involved (professional event technics)....
