Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am having an odd issue where if my traffic has to be routed I get approximately 10% of line rate. I have attached a drawing that shows a subset of my network which will hopefully make clear what I am doing.I have multiple subnets on VLAN 200...
Hello,I am trying to configure the management interface on the back of a Cisco 4331 router and am having a hard time wrapping my head around getting it to work. I read through the 6 page Cisco doc "Configuring ethernet management port" and it seems ...
Definitely, and I do expect a bit of a drop in throughput due to latency and overhead, just not a 90% drop. I thought there had to be something misconfigured or just a mess since there were several subnets all on the same VLAN being routed over the ...
Well then, that is probably the issue. I will look into licensing to see if I can definitively identify that as my bottleneck. I was pulling my hair out trying to figure out if my VLANs were magically crippling the network..but not looping to event...
