Our customer is asking about the occurence of CPU spikes. From the PIX documentation:"%PIX-3-211003: CPU utilization for time seconds = %cpu_usage Explanation: This message is displayed if the percentage of CPU usage is greater than 100% for time s...

We are using a Failover Cable for failover. We are also using stateful failover between the PIX 515 firewalls using a FastEthernet interface. I really need some info about the following:1. If the failover cable fails (or was removed), while the 2 fir...

We have 2 networks separated by 3 routers (L3 switches) in parallel via WAN. AFAIK, RIP will load balance on these 3 routes. How do I influence the routes (metric) so that Router-1 is preferred over Router-2 and Router-3? Is it possible? If not, what...

Searched CCO but found no info. Searched Google and found the foloowing:"They are for Cisco Proprietary Protocols use on Cisco Catalyst 6000 Network Analysis Modules."Any other useful information about this port? We don't have NAMs on any of the Cat...

I've seen this command in one of our customer's switches. I have checked the Cat2950 command reference but I didn't find the command. I also tried searching CCO and the Command Lookup Tool for the usage guidelines but I can't find such command. Is it...